S3C6410 u-boot源码分析之cup_init.S

1、#include <s3c6410.h>

.globl mem_ctrl_asm_init
mem_ctrl_asm_init:
ldr r0, =ELFIN_MEM_SYS_CFG@Memory sussystem address 0x7e00f120
mov r1, #0xd@ Xm0CSn2 = NFCON CS0, Xm0CSn3 = NFCON CS1
strr1, [r0]下图的黄色部分表明这出设置的作用，但我不明白，为何要设为0xd，要实现这个目标@ Xm0CSn2 = NFCON CS0, Xm0CSn3 = NFCON CS1，好像与此处设计无关？

注：? Memory port 0 is shared by using EBI （External Bus Interface）.
? Memory port 1 is used only by DMC1.
? EBI module supports the share of pad interface used by 5 memory controllers （SROMC, two OneNANDCs,
CFCON, and NFCON）.
SHARING CHIP SELECT FOR MEMORYPORT 0
The decision of which memory controller owns specific memory bank is decided both by following three
factors.
? Booting mode
? MP0_CS_CFG regsiter residing in System Controller
? XSELNAND input port value

2、ldrr0, =ELFIN_DMC1_BASE@DMC1 base address 0x7e001000
只读寄存器。

3、ldr r1, =0x04
str r1, [r0, #INDEX_DMC_MEMC_CMD]
#define INDEX_DMC_MEMC_CMD （0x04）
看到下面的图，应该知道为什么了吧？配置为：Configure模式

4、其中有两个寄存器没赋值，如下所示：

下面那个可能采用的是默认值。而上面的是只写寄存器，可能不需要赋值。